Search results for "electric [mass]"

Optimization of a Sea Wave Energy Harvesting Electromagnetic Device

2008

This paper presents the optimization of a permanent magnet linear generator directly coupled to sea waves. In order to maximize energy extraction, the stochastic features of the energy source is included in the mathematical model of the system in order to satisfactorily tackle the problem. An optimization procedure which includes the stochastic features of the model is presented and a machine built on the basis of the results of this procedure is shown.

Low-Temperature Solution Processable Electrodes for Piezoelectric Sensors Applications

2013

Piezoelectric thin-film sensors are suitable for a wide range of applications from physiological measurements to industrial monitoring systems. The use of flexible materials in combination with high-throughput printing technologies enables cost-effective manufacturing of custom-designed, highly integratable piezoelectric sensors. This type of sensor can, for instance, improve industrial process control or enable the embedding of ubiquitous sensors in our living environment to improve quality of life. Here, we discuss the benefits, challenges and potential applications of piezoelectric thin-film sensors. The piezoelectric sensor elements are fabricated by printing electrodes on both sides of…

An impedance study of complex Al/Cu-Al2O3electrode

2011

Electrochemical impedance spectroscopy (EIS) was used to investigate different Cu deposition regimes on Al surface obtained by internal electrolysis and to characterize properties of fabricated electrodes. EIS experimental data confirmed that Cu deposition by internal electrolysis is realized and the complex electrode system is obtained. The main difficulty in preparation of Al/Cu electrodes is to prevent aluminium oxidation before and during electrochemical deposition of Cu particles. In this work NaCl, CH3COONa, K2SO4, mono- and diammonium citrate electrolytes were examined to determine their suitability for impedance measurements. Al/Cu-Al2O3 electrode composition was approved by equival…

Intracranial measurement of current densities induced by transcranial magnetic stimulation in the human brain

2003

Transcranial magnetic stimulation (TMS) is a non-invasive technique that uses the principle of electromagnetic induction to generate currents in the brain via pulsed magnetic fields. The magnitude of such induced currents is unknown. In this study we measured the TMS induced current densities in a patient with implanted depth electrodes for epilepsy monitoring. A maximum current density of 12 microA/cm2 was recorded at a depth of 1 cm from scalp surface with the optimum stimulation orientation used in the experiment and an intensity of 7% of the maximal stimulator output. During TMS we recorded relative current variations under different stimulating coil orientations and at different points…

Flux density at the airgap of small DC motors with different permanent-magnet poles

1993

Residual strain effects on the two-dimensional electron gas concentration of AlGaN/GaN heterostructures

2001

Ga-face AlGaN/GaN heterostructures with different sheet carrier concentrations have been studied by photoluminescence and Raman spectroscopy. Compared to bulk GaN, an energy shift of the excitonic emission lines towards higher energies was observed, indicating the presence of residual compressive strain in the GaN layer. This strain was confirmed by the shift of the E2 Raman line, from which biaxial compressive stresses ranging between 0.34 and 1.7 GPa were deduced. The spontaneous and piezoelectric polarizations for each layer of the heterostructures have been also calculated. The analysis of these quantities clarified the influence of the residual stress on the sheet electron concentratio…

Influence of Compensating Defect Formation on the Doping Efficiency and Thermoelectric Properties of Cu2-ySe1–xBrx

2015

The superionic conductor Cu_(2−δ)Se has been shown to be a promising thermoelectric at higher temperatures because of very low lattice thermal conductivities, attributed to the liquid-like mobility of copper ions in the superionic phase. In this work, we present the potential of copper selenide to achieve a high figure of merit at room temperature, if the intrinsically high hole carrier concentration can be reduced. Using bromine as a dopant, we show that reducing the charge carrier concentration in Cu_(2−δ)Se is in fact possible. Furthermore, we provide profound insight into the complex defect chemistry of bromine doped Cu_(2−δ)Se via various analytical methods and investigate the conseque…

Study of the annealing conditions and photoelectrochemical characterization of a new iron oxide bi-layered nanostructure for water splitting

2016

Iron oxide nanostructures have emerged as promising materials for being used as photocatalysts for hydrogen production due to their advantageous properties. However, their low carrier mobility and short hole diffusion length limit their efficiency in water splitting. To overcome these drawbacks, in the present study, we synthetized a new hematite (alpha-Fe2O3) bi-layered nanostructure consisting of a top nanosphere layer and a nanotubular underneath one by electrochemical anodization. Annealing parameters such as temperature, heating rate and atmosphere were studied in detail in order to determine the optimum annealing conditions for the synthetized nanostructure. The obtained new bi-layere…

Molecular monitoring of inactivation efficiencies of bacteria during pulsed electric field treatment of clinical wastewater

2008

Aims:  The applicability of an alternative wastewater disinfection concept based on the pulsed electric field (PEF) treatment is tested with molecular biology techniques using clinical wastewaters. Methods and Results:  Hospital wastewater was treated with the PEF technology. The inactivation efficiencies of bacteria were successfully monitored with real-time polymerase chain reaction (PCR). As the differentiation between living and dead bacterial cells is important for the determination of the disinfection efficiency, propidium monoazide (PMA) was applied. PMA selectively penetrates cells with compromised membranes and intercalates into the DNA inhibiting a subsequent PCR amplification. Th…

Elektromašīnas, 1. daļa: Transformators [lekciju konspekts]

1941

Konspekts ar rokraksta tiesībām. Lasīts Latvijas Valsts Universitātes Mehānikas fakultātē.